Characterization of Hydrochar Produced by Hydrothermal Carbonization of Organic Sludge
DOI:
https://doi.org/10.5334/fce.102Keywords:
hydrothermal carbonization, organic sludge, hydrochar, severity factorAbstract
Sludge is a serious problem due to the risks to environment. Therefore, an energy-efficient, economic-feasible and environmental sustainable measure for sludge management is urgently required, while hydrothermal carbonization (HTC) has been regarded as one promising method. In this study hydrothermal carbonization was utilized to convert organic sludge (OS) into solid carbonaceous product (hydrochar) under various reaction temperature (T = 180–240 °C) and residence time (t = 60–240 min), respectively. The reaction pressure ranged from 2.7 to 4.8MPa, depending on the reaction conditions. The obtained hydrochar was analyzed by elemental analysis, proximate analysis, SEM, FTIR, and BET, to investigate the effect of reaction parameters on the hydrochar properties, followed by discussions on potential applications of the obtained hydrochar. Obvious reduction of H/C and O/C ratio after HTC was observed, based on the Van Krevelen diagram and FTIR analysis, revealing that the dehydration and decarboxylation occurred during the HTC process. The reaction temperature was regarded as the dominant parameter affecting hydrochar characteristic, compared to residence time. The severity factor (log Ro) at the range from 4.13 to 5.90 showed good linear relationship with the ash content, volatile matter (VM), N content and H/C ratio of hydrochar, indicating that the severity factor could serve as a useful indicator for analyzing the hydrochar property. Although the surface area and porosity were improved by HTC, subsequent modification and activation should be needed to broaden the application field. Owing to the characteristic of high ash content, hydrochar derived from organic sludge might not be feasible for fuel use. Instead, the precursor of the activated carbon and low-cost adsorbent might be the potential applications, while further works should be needed to verify the feasibility.Published
2020-12-28
Issue
Section
Technical Articles
License
Copyright (c) 2020 The Author(s)
![Creative Commons License](http://i.creativecommons.org/l/by/4.0/88x31.png)
This work is licensed under a Creative Commons Attribution 4.0 International License.
Authors who publish with this journal agree to the following terms (if a submission is rejected or withdrawn prior to publication, all rights return to the author(s)):- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).
Submitting to the journal implicitly confirms that all named authors and rights holders have agreed to the above terms of publication. It is the submitting author's responsibility to ensure all authors and relevant institutional bodies have given their agreement at the point of submission.
Note: some institutions require authors to seek written approval in relation to the terms of publication. Should this be required, authors can request a separate licence agreement document from the editorial team (e.g. authors who are Crown employees).